The compact Flashfish A501 power storage unit is ideal for supplying electrical consumers with up to 500 W of power on the go. Voonze tested it and reveals why the model is less suitable for campers.
Power stations supply electrical consumers independently of the power grid. Thanks to various connection options including 230 V socket, 12 V output, USB ports and a high continuous output, the devices are ideal for leisure, work and as an emergency power supply. The internal batteries can be charged either via the power pack, via a 12 V socket in the vehicle or with the help of a photovoltaic panel. The devices offer maximum flexibility.
This power station test is part of the Outdoor and Camping theme worlds . Here we show, for example , high-tech gadgets for hiking , binoculars with a range finder or explain what to look out for when buying a flashlight .
This individual test is about a power station from the manufacturer Flashfish in the middle performance segment. In addition to two sockets with up to 500 W and a capacity of 540 Wh, the price, which was reduced to 477 euros at the time of the test, is also attractive . The test device was made available to us by Geekmaxi for the test.
The Powerstation A501 is housed in an anthracite-orange plastic housing with an attached handle. However, this is not foldable and so it is unfortunately not possible to put other things on it. We also find a similar design on other models from Flashfish, Revolt or Xmund. With a weight of 6.4 kg and dimensions of 33 × 20 × 24 cm, the power storage is still mobile, but actually too big for a backpack. Overall, the model is very stable. It’s a pity that all connections are open and not protected against dirt.
The power button for the DC outputs is on the left on the front and three circular sockets for 12 V consumers (maximum 10 A) are underneath. The 12 V car socket is at the bottom (cigarette lighter maximum 10 A). On the right side are the power button for direct current, the status display and the main power switch. The five USB sockets are installed directly below. In addition to two USB-C sockets with a maximum of 60 W, three USB-A slots with 2 A are also available. Below the USB ports are the two Schuko sockets for 230 V consumers. These provide a maximum of 500 W pure sine wave. Unlike the Revolt power station, for example, sensitive technology can also be connected here.
A large emergency lamp with a switch is located on the back. The power-in connection for the power pack or solar panel can be found on the left side of the case below the fan opening.
In addition to the power station, the 100 W power pack and a 12 V car plug, a quick start guide is also included in the scope of delivery. A solar panel is not included, for the test we used a suitable universal panel from iMars (100 W). The Li-Ion batteries used in the A501 are slightly lighter than comparable LiFePO4 batteries. The disadvantage is the significantly shorter service life of only about 500 to 800 charging cycles – that’s comparatively little. LiFePO4 batteries, as in the Bluetti EB70 (test report) , retain 80 percent usable capacity even after over 3000 cycles.
practice test
Operating the Flashfish power station is easy and self-explanatory thanks to the labeling and clear layout. To switch the power station and the respective outputs on and off, it is sufficient to press the corresponding power button for several seconds. The same applies to activating and switching through the light modes of the side LEDs.
After switching on, the small status display lights up. Thanks to the good contrast and sufficient brightness, this can also be read outdoors. Unfortunately, the information content of the display is comparatively low. It shows the percentage of remaining capacity, which ports are on (DC and AC), and whether power is being output or charged. Remaining time display or performance are not visible.
Before fully charging, we test the maximum performance of the A501. To do this, we plug in various consumers, such as tools, computers or kitchen appliances. The power station delivers the specified 500 W. Short peaks of up to 1000 W are also possible. But only for a few seconds, then the power station switches off the 230 V outputs. The buffer is sufficient for the increased starting current (750 W) of our PC workstation. Since the 230 V is emitted as a pure sine wave, the power supply for our sensitive laser printer also works.
However, the Flashfish A501 lacks the power for electric grills, kettles, toasters, fan heaters or circular table saws. The sometimes more than 2000 W lead to the immediate switching off of the power outputs. However, the power station is well suited for moderate consumers such as chargers, drills, jigsaws or our lawn trimmer.